Outgoing Call Restriction Button (#114)
5-207
Valid Entries
1 = Assigned to next available button at extension 10
2 = Not Assigned
✔
3 = Select button (then press a programmable button with lights to assign
Outgoing Call Restriction to that button)
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program an Outgoing Call Restriction button at extension 10:
1. Press
f 0 0 s s # 1 1 4 at extension
10.
2. At this point:
■ If you want to assign Outgoing Call Restriction to the first available
button, press
D until a display similar to the following
appears:
Outgoing CallRstr Button
1 Assigned - Ext10
■ If you want to remove the Outgoing Call Restriction button
assignment, press
D until a display similar to the following
appears:
Outgoing CallRstr Button
2 Not Assigned
■ If you want to assign Outgoing Call Restriction to a specific button,
press
3. A display similar to the following appears:
Outgoing CallRstr Button
3 Select a Button
Then press a programmable button with lights to assign Outgoing
Call Restriction to that button.
3. Select another procedure or exit programming mode.
4. Label the Outgoing Call Restriction button at extension 10.
To Next Page
Loading...
