Recall (F03)
5-225
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To program a Recall button:
1. Press
f 0 0 s s c at extension
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press
f 0 3.
5. Program another button for this extension or exit programming mode.
Using
To access a PBX, central office, or Centrex feature (such as Call Waiting) while
active on an outside line:
System Phone
1. Press the programmed button or press f 0 3.
2. Enter the access code for the feature (if required).
3. To return to your original call, press the programmed button or
press
f 0 3 again.
Standard Phone
1. Press the switchhook (or press the Recall or Flash button on a feature
phone that has one).
You hear intercom dial tone.
2. Press # 0 3.
3. Enter the access code for the feature (if required).
4. To return to your original call, press the switchhook (or press the Recall or
Flash button on a feature phone) again.
To Next Page
Loading...
Need help?
General
