Remote Administration Password (#730) —Release 3.0
or Later
5-231
3. Enter or change the password by entering the two-digit character codes
found in Extension Name Display, Table 5.1.
4. To save the password, press
e. The bottom line of the display shows
the password as it has been entered.
5. Select another procedure or exit programming mode.
6. To remove an existing password, repeat steps 1 and 2 and press
r.
7. Select another procedure or exit programming mode.
Using
For more information about administering your system remotely from a PC, see
the
Getting Started Guide
which accompanies the PARTNER ACS Release 3.0
Remote Administration Software.
To Next Page
Loading...
Need help?
General
