LUMENIS UltraPulse - Setting Treatment Values; Setting the Power

Setting Treatment Values  89
UltraPulse
0637-129-01, Revision G
Setting Treatment Values
In CW (continuous wave) mode, the available treatment settings are power,
timed exposure, and repeat delay. To select CW mode, press the CW tab at
the top of the control screen.
Setting the Power
Press the and buttons on the power bar.
CAUTION - The power shown on the power display indicates the power
delivered to the end of the articulated arm, not necessarily the amount
delivered to the treatment site. Consult your delivery system operator manual
to determine if the delivery system introduces a transmission loss to the final
output power.
CW—Setting the Power
W
60 W
10 ms
0.10 s
I
I
SurgiTouch + UltraPulse CW
Options
W
60 W
Increase power
Decrease power