How to fix RS-232 control issues with Lumens Camcorder?
If you cannot control your Lumens Camcorder via RS-232, first confirm that the connection is correct, using the RS-232 In/Out ports. Also, ensure that the baud rate setting on the camcorder matches that of the control equipment.
Why ONVIF software cannot locate my Lumens Camcorder?
If ONVIF software cannot locate your Lumens Camcorder, it may be due to special characters or spaces in the camera's location settings. Ensure that you only use English alphabets or numbers in the [Setting]>[Video]> [Camera](Location) section of the webpage.
What to do if Lumens VC-A71P does not save parameters after reboot?
If your Lumens Camcorder doesn't save parameters like PTZ or AWB after a reboot, make sure the Initial Position is set to Last Operated Position in the setting menu or web page.
How to enable Tally lamp on Lumens Camcorder with RS232 setting?
If the tally lamp on your Lumens Camcorder isn't working with RS232 settings, verify that the Tally lamp function is enabled in the setting menu or web page.
To Next Page
General
