Web interface
Status
The complete device can be configured from an intuitive Web interface.
You just have to browse to the IP address of the unit. If you do not know
the IP address, you can quickly discover it through the front end display or
by running Luminet Monitor V2 software (free downloadable tool), which
shows all Luminex nodes on the network.
Make sure that the computer, you use to browse, is setup in the correct
network address range (IP 2.x.x.x or 10.x.x.x and subnet 255.0.0.0).
When you're not using a complete network setup (Ethernet switches,
hubs, routers, WLAN, ...), you can also use either a cross Ethernet cable
or straight Ethernet cable to directly connect the unit to your computer.
After all connections and setup on the computer are completed, open your
favorite web browser (we recommend Firefox) and enter the IP address
you want to reach in the URL field : Http://2.x.x.x
You'll end up at the status page of the device. This page has a complete
overview of the device settings. The overview shows the actual DMX and
network setting / routing of the complete device.
The Web interface offers several languages. Select the language that fits
your needs in the drop down menu located on the top right side of the
Web page.
Page 14 of 35 Ethernet - DMX8 MkII Range
Navigation Bar
Actual DMX routing
Actual Global settings
Actual Network settings
To Next Page
Loading...
Need help?
General