• Global
Some global settings can be altered by clicking Global in the Setup sub
menu. Device Settings
Here you can change the device's ID number which is indicated on
LumiNet monitor.
You can also enable the Trigger universe to remotely control your merging
policy through any DMX source. The node will listen to the specified
universe entered in the universe field.
You can set your Recover channel if you use the manual recovery mode
(page 19, 24).
DMX details
The DMX frame rate setting for all outlets. This can be set from 20 to 40
frames per second. Break Time can be set from 176 to 352µs.
DMX Output time can be set to 1 – 10 minutes or continuously. This time
sets how long an output remains outputting it's last DMX levels after no
valid DMX packet came in for that particular universe on Art-Net™ or
sACN.
Ethernet - DMX8 MkII Range Page 27 of 35
To Next Page
Loading...
Need help?
General