Toubleshooting
• The Power/OK LED is always blinking:
You're Ethernet-DMX8 MkII doesn't boot properly. Restart the unit
with the power switch. If this doesn't help, contact your local dealer.
Please note the Power/OK LED will be blinking during upgrade
procedure, don't switch off the power during this step.
• My computer is connected to the node, but the Link/Activity
LED is still off.
Check the Ethernet cable you're using, and check that each RJ45 on
each side of the cable is properly inserted. Feel free to plug another
cable to isolate the problem.
• I can't reach the Web interface of the Ethernet-DMX8 MkII
Please check first the two previous steps. Then please be sure your
computer is set in the same IP range than your Ethernet-DMX8
MkII. Try to ping the unit with a dedicated application, such as a
DOS session on Windows, or a terminal session on MAC. You can
use LumiNet Monitor V2 to discover your Ethernet-DMX8 MkII. If
you can't see your device in LumiNet Monitor V2, please contact
your local dealer.
Page 34 of 35 Ethernet - DMX8 MkII Range
To Next Page
Loading...
Need help?
General