Connectivity
Rear Panel – Side Panel
• Mains
Ethernet-DMX8 MkII
The device operates with an AC voltage between 90V and 260V within a
frequency range of 47Hz and 63Hz.
An IEC socket is located at the rear of the unit. Please use an IEC plug
compliant cable to feed power to the unit.
Luminex recommend the use of a power cable, fitted with an IEC-Lock™
plug. The IEC-Lock™ system offers a reliable way to connect the power
cable to the unit.
!!! This equipment must be earthed !!!
• Punched holes
The unit offers 8 punched holes to easily install 8 optional DMX input
connectors, or to reverse the board.
• Ethernet
1 Neutrik RJ45 Ethercon is provided as Ethernet link.
Page 8 of 35 Ethernet - DMX8 MkII Range
Punched Holes
10/100Mbps Ethernet ports
IEC Inlet
Powercon socket
DMX connectors
Fuse holder
To Next Page
Loading...
Need help?
General