Luminex LumiNode Series - How to Reset a Process Engine; How to Configure a Process Engine

How to reset a process engine
To reset a process engine, follow the following steps:
 Hover your mouse over the top left corner of the process
engine and select the tick box.
 Click on the trash can icon at the top right corner above the
first process engine.
A blank process engine appears as follows:
If you want to reset all the process engines at once, navigate to
the top left above the first process engine and select the tick box
“Select all Process Engines”.
How to congure a process engine
To configure a process engine, first click on the “SELECT MODE”
label (the centre block of the process engine), the process engine
panel appears. Click on the icon to select the mode you wish to
use. Modes are described in chapter 5 of this manual.
 Forward an input is sent to an output .
 LTP merge, Latest Takes Precedence with up to four
inputs
.
 HTP merge, Highest Take Precedence with up to four
inputs
.
 Backup, Input 2 becomes active if input 1 is not available .
 X-Fade, Cross-fade between input 1 and input 2 .
 Switch, with the use of a control source choose which of the
up to four inputs is+ active
.
 Custom, any of the other modes, or combination of,
on a channel level
.
At any time, you can click on the Patch button
, or the Master
/ Limit button
to open the relevant configuration panel.
Next, click on the left-hand block, to select your input
. Ac-
cording to the selected mode, the number of inputs may vary. A
process engine supports up to four inputs.
Input options are:
 DMX: Physical input on the XLRs.
 ArtNet: Select the ArtNet universe to use. You can enter a
numeric value between 0 and 32767.
 sACN: Select the sACN universe to use. You can enter a
numeric value between 1 and 63999.
 RTTrPL, BlackTrax: Select the RTTrPL universe to use. You can
enter a numeric value between 0 and 63999.
 Internal, the result of another process engine.
 Play, one of the recorded shows.
You can give your input a name for easy identification. Next, select
your output
by clicking on the output block, located on the
right-hand side.
Here, you can choose between DMX, ArtNet, sACN or a combina-
tion of the three to send data coming from the process engine.
The three types of output can be used at the same time, providing
you with great flexibility.
Once selected, click on the Save button to store the parameters of
your process engine. Your engine is ready to go!
10
2 | CONFIGURATION / 2.1 WEB INTERFACE PRESENTATION / RESET & CONFIGURE A PROCESS ENGINE