Luminex LumiNode Series - Installation; Mounting the device

1. INSTALLATION
1.1 Mounting the device
Depending on the model of the device there are different mount-
ing options:
LumiNode 4 is a device that can be mounted in a truss as well as
in a rack. Please read the following instructions to make sure the
device is mounted and secured correctly.
RACK MOUNT  LumiNode 4
In case you want to mount your LumiNode 4 in a standard 19-inch
rack, you must attach the included mounting ears. Connect the
longest ear (A) to the right-hand side of the device with 4 screws,
re-used from the device. Attach the shorter ear (B) to the left-hand
side again with the 4 screws.
RACK MOUNT  TWO DEVICES
In case you want to mount two LumiNode 4 devices or a Lumi-
Node 4 and a LumiCore in a standard 19-inch rack you can mount
the two devices together. A space saving way as the two devices
will only consume a single row in your 19-inch rack.
First you attach the shortest mounting ears. Connect the short-
est ear (C) to the left-hand side of the first device with 4 screws,
re-used from the device. Attach the other shortest ear (D),
delivered with the second device, to the right-hand side of the
second device, again with 4 screws. Use a pair of mounting brack-
ets (E) to connect the two devices in the middle on the frontside.
Use a second pair of mounting brackets (E), delivered with the sec-
ond device, to connect the devices at the rear. Each pair of brack-
ets musts be mounted with 2 screws.
A
B
A A
B B
C C
D D
E E
F F
G G
H H
12
12
11
11
10
10
9
9
8
8
7
7
6
6
5
5
4
4
3
3
2
2
1
1
C
E
E
D
4