How to quickly copy a process Engine
Once you have created your first process engine, select it by click-
ing on the tick box in the top left corner. A handle appears at the
bottom centre of the process engine.
Click and drag the handle down, to select other process engines.
The LumiCore will automatically increase the universe number for
each following process engine. This allows you to create a com-
plete configuration in a snap!
THE DMX / RDM PAGE
The DMX / RDM page is divided in two sub menus:
Port Settings
The port settings oers you to:
Add a legend to a port to easily identify what is connected to
it. This will also update the tooltip on the configuration page
of the process engine.
Enable Sync mode: when enabled the DMX output framerate
is matched to the input framerate. If the source used for this
port has the ability to send an ArtNet or sACN sync packet this
will be used.
Redundant Slave: when enabled the DMX port listens to
incoming DMX from another port or another node and will
start outputting if NO input is registered. When DMX redun-
dant slave is enabled RDM is automatically disabled.
Enable RDM, enabling RDM allows RDM traffic to be
transported from/to an outlet over the network and back.
• Adaptive discovery. When RDM is enabled it is possible to
enable Adaptive Discovery. This will continuously check
for new and disappeared RDM devices on the output.
• Interweaving. Interweaving is enabled by default. Inter-
weaving is only available when the FPS is set lower or
equal to 34fps. Interweaving makes that RDM messages
are interweaved with DMX. If your fixture does not support
interweaving or the RDM packets you are sending are too
large you would disable RDM interweaving. For example,
with a RDM based follow-spot system interweaving needs
to be disabled.
• ArtRDM universe. The ArtRDM universe is the universe
which is used for ArtTOD and ArtRDM packets. By default,
this will be matched to the ArtNet universe of the first Art-
Net input of your process engine.
Scroll down and click “Save” to save your settings.
At the bottom of the process engine section you can find a button
to force an RDM discovery in case this is required.
DMX Settings
On the DMX / RDM page at the bottom of the page you find the
DMX settings.
DMX Framerate in Frames Per Second
Breaktime in microseconds
DMX output time continuous by default is enabled and the
LumiNode will keep outputting the last received stream
packages on the DMX. When you disable the continuous out
put time you can choose a time the LumiNode will keep
outputting the data with a minimum time of 1 second.
RDM Controller IP is the only device in the network that can
make changes via RDM. When 0.0.0.0 every device in the
network can make changes but if you want to have a
dedicated device to manage the RDM you can define the IP
here.
Press “Save” to apply your settings
11
2 | CONFIGURATION / 2.1 WEB INTERFACE PRESENTATION / QUICKLY COPY A PROCESS ENGINE / DMX RDM PAGE
To Next Page
Loading...
