1.2 Power up the device
Depending on the model there are different ways to power your
device:
LumiNode1: Power-up the device with a USB cable (U) or with
PoE (N). The device will automatically switch on. To shut it down
after use, just un-plug the USB cable or the network cable again.
LumiNode2: Power-up the device with a network cable with PoE
(N). The device will automatically switch on. To shut it down after
use, just un-plug the network cable again.
LumiNode4 and 12: Power-up the device with a power cable fitted
with a Neutrik PowerCON TRUE1 connector (M) (please contact your
local dealer if you do not have a suitable power cable at hand). The
device will automatically switch on. To shut it down after use, just
un-plug the power cable again. LumiNode4 and 12 can also be
powered with PoE (N).
The LumiNode 4 and 12 require standard AC power distribution from
100-240VAC, 50/60Hz. Current required depends on the model.
The mating Neutrik® powerCON® TRUE1 connector is supplied; how-
ever, you will need to purchase or construct a cable appropriate for
your application.
When installing a new connector please refer to the following wire
colour code reference:
WIRE* CONNECTION
Green/Yellow AC Ground
Blue AC Neutral
Brown AC Line
* International (Harmonised) Standard
Alternatively, the LumiNode series are 802.3af compliant (PoE), so
that each LumiNode will act as a PD (Powered Device) and can be
powered by any compliant PSE (Power Sourcing Equipment) such
as Ethernet switch, midspan and PoE injector. All models can only
be powered with PoE via Eth2!
For LumiNode 4 and 12, if both AC power and PoE are used the AC
power supply will be prioritized but the PoE will seamlessly take
over if the AC power fails.
The LumiNode12 offers the option to daisy chain up to 30 devices
via the PowerCON TRUE1 outlet on the rear of the unit.
U
N
LUMINODE 1
LUMINODE 2
N
LUMINODE 4
N M
LUMINODE 12
N M
7
1 | INSTALLATION / 1.2 POWER UP THE DEVICE
To Next Page
Loading...
