Luminex LumiNode Series - Toolbox Page; Profile Manager; Firmware

TOOLBOX PAGE
The toolbox page is divided in three sub menus:
Prole manager
Here, you can recall, save, import, export or delete a profile; Select
the profile with the drop-down menu located on left hand-side.
The LumiNode comes with default profiles that can be used or
modified, for a fast setup time. Up to 40 profiles can be stored in
a unit.
Once a profile is selected, you can preview the configuration be-
low. IP settings included in the profile are displayed at the bottom
of the profile.
When a profile has been selected the user can scroll down to
the bottom of the profile preview to see the IP settings in this
profile. By default, the LumiNode will NOT load the IP settings
that are stored in the profile. If you want to load the IP set-
tings saved in the profile, slide the “Preserve IP settings” to OFF.
Firmware
Here, you can see two types of firmware:
 Active rmware is the one currently running on the unit.
 Alternate rmware is the previously installed rmware.
If you’d like to downgrade the unit to the previously installed firm-
ware, click on the “Activate” button. The unit will reboot with this
firmware.
There is only ONE rmware version for the entire range. This
can be installed on all dierent models in the range.
You can upgrade the LumiNode with our latest rmware. To
upgrade the unit, please apply the following procedure:
 Download the latest firmware from the support section of our
web site.
 Extract the downloaded archive and have a look at the release
notes included.
 Click on the firmware upgrade button.
 Select the file you have extracted.
 The LumiNode will start the firmware upgrade. The unit will
reboot after the upgrade is completed.
14
2 | CONFIGURATION / 2.1 WEB INTERFACE PRESENTATION / TOOLBOX PAGE / PROFILE MANAGER / FIRMWARE