Luminex LumiNode Series - Internal; Play; Output; DMX

For a better identification of the source you can add a text to your
RTTrPL input.
Internal:
This input option allows you to use the output of another process
engine, this allows you to make even more complex setups. Use
the dropdown menu to select which process engine you want to
use as input.
For a better identification of the source you can add a text to your
Internal source.
Play:
This input option allows you to use the recorded cues from in-
ternal shows as an input to the process engine. First select which
show you want to use, then select the process engine that you
want to use. All the process engines of the LumiNode are always
available to choose from. For a better identification of the source
you can add a text to your Play source.
Select the control channel you want to use to control the cue list.
Use the cog wheel to set the source protocol and universe and if
required a specific controller IP.
Control channel options:
8 – 15 Go, play the next cue in the cue list.
16 – 23 Forward, preset the next cue. This allows you to trigger
forward for example twice to skip a cue.
24 – 31 Back, preset the current cue again. To go to the
previous cue, you need to trigger this option twice.
32 – 39 Reset, reset the cue list to the first cue in the list.
OUTPUT
A process engine offers the following outputs:
DMX:
One or several DMX ports can be selected to output the data
transferred by the process engine. A greyed-out port with a bar in
the middle, means this port is already used.
ArtNet:
All data handled by the process engine can be sent back to the
network as a new or the same ArtNet universe.
Here you can set the universe number you wish to use. You can
specify the IP address of the destination, by ticking the Unicast
box. By default, the LumiNode will transmit this ArtNet universe to
the broadcast address of the IP range the unit is part of.
For a better identification you can add a text to your ArtNet des-
tination.
sACN:
All data handled by the process engine can be sent back to the
network as a new or the same sACN universe.
Here you can set the universe number you wish to use, and you
can specify the priority for this sACN universe.
For a better identification you can add a text to your sACN desti-
nation.
23
5 | LUMINODE IN DETAIL / INPUT  PLAY / OUTPUT