PONTOON COVER INSTALLATION
INSTRUCTIONS — CARE & USE
GUIDELINES
Please carefully read this entire instruction sheet before
proceeding.
It is very important to us that you read and understand
these installation instructions. If while reading these
instructions you are unsure about installing the cover,
please feel free to contact the dealer where you purchased
your boat. Improper installation as a result of not following
these instructions may result in damage to the cover that is
not covered by the warranty.
INSTALLATION
Pontoon covers are not designed to be trailered. The
limited warranty does not cover damage caused by
trailering
NOTE: The canopy or Bimini top must be in the position
shown during installation of the cover. It may also be
necessary on some pontoon models to remove and store
the windshield (Fig. 1&2)
Positioning and Fastening the Cover
Unfold the cover and locate the tag that reads “FRONT”
sewn into the underside of the cover. This side of the cover
should be placed toward the front of the pontoon. Unfold
and lay the cover over the top of the pontoon. Pull the
corners to their positions (front and rear).
Check for proper fit in all critical areas such as the corners
and canopy/Bimini mount bracket openings. These
https://www.boat-manuals.com/lund/
To Next Page
Loading...