CARING FOR YOUR BOAT
brackets should be in the center of the openings in the
cover. Pull the short rope in the collar of the openings tight
and tie a knot.
Make sure all corners and sides of the cover are pulled
evenly and the cover is centered on the pontoon. This is
critical in assuring proper fit.
After checking for proper fit you may begin attaching the
cover to the pontoon. Your pontoon has the Dowco-Clip
system you can snap on the clips starting at the center of
the front of the pontoon. Then attach the front corner clips
making sure the cover is pulled tight. Locate the rear
corner clips, pulls the cover tight and fasten those. Next
you can attach the remaining clips on the front, rear and
sides.
If your cover has metal snaps instead of the EZ-Clip
system, fasten the snaps in the same manner described
for the clips.
The cover will be loose down the center of the pontoon
and will be raised and tightened using the support poles
supplied to create a tent affect so that water drains off to
the sides properly.
Cover Support Pole Placement for Proper
Drainage
Some covers come with adjustable support poles. To place
the poles you may need to crawl inside the boat under the
cover. When the poles are placed in position, they will help
to insure proper drainage. The poles can be adjusted to
raise the cover until it is taut (no sags) and allows water to
drain off.
NOTE: Avoid overextending the poles and stretching the
fabric. Poles can be made shorter by removing the black
end cap and placing it on the opposite end and
reassemble.
https://www.boat-manuals.com/lund/
To Next Page
Loading...