For covers with plastic vents – insert the pole end without
the cap into pole vent.
For covers with pole pockets – insert the pole end with the
cap into the pocket sewn into the underside of the cover.
Adjust each of the poles until the entire cover is evenly
raised and taut so that water can drain off.
Some poles may be positioned near rear seat cushions. In
some cases, the rear seat may be flipped up and the pole
placed inside and down to the deck.
PREVENTING TEARS
At this time look for possible points of abrasion (sharp
objects or angles) where the cover may rub and be
damaged. Add protective padding (foam or soft cloth) as
needed.
STORAGE AND CARE
Proper care and maintenance of the cover will maximize its
useful life. The ClimaShield™ fabric used for the cover has
coatings for water repellency and mildew resistance. It is
important to follow these instructions to maintain these
benefits.
Never store the cover while it is wet or dirty. Make sure the
cover is completely dry and clean prior to storage as this
will help prevent mildew growth which will damage the
fabric.
Clean the cover with mild soap and water to remove dirt,
bird droppings, etc. Do not steam or pressure wash.
Prevent sharp objects, solvents and hot items from coming
in contact with the cover.
If stored outdoors, do not allow ice or water to accumulate
on the cover as this may cause damage.
https://www.boat-manuals.com/lund/
To Next Page
Loading...