SYSTEMS AND COMPONENTS
transom and flood the boat. Gradually increase speed
when moving in reverse.
Steering
Various steering systems are used on boats. Some models
have a tilt steering wheel and an enclosed push-pull cable
system connected to the motor. A hydraulic steering
system is avail-able as an option on some models.
Getting the “feel” of your boat’s steering system is
important. Steering does vary from boat to boat depending
on the type of engine, water and wind conditions and the
load. Turn the wheel from full left to full right. Check that
the drive unit is turning correctly, freely and smoothly. The
cable output end of the steering system should be clear of
fuel lines, control cables, electrical wiring and outboard
gear when an engine is moved through its full operating
range. Be careful not to kink the cables.
All steering systems require periodic maintenance to be
trouble-free and safe. Regular checks are essential. Check
the cables regularly and tighten them as needed. Be sure
to read the manufacturer supplied operator’s manual
before heading out on the water.
None of the steering systems are self-centering. That is,
none will go back to center automatically. You must turn it
back to center.
NOTE: If your boat has power steering equipment, refer to
the engine owner’s manual for detailed information
regarding steering system operation and maintenance.
Hydraulic Steering System
A hydraulic steering system is available as an option for
some models. Hydraulic steering makes it easier to control
the boat because the wheel is easier to turn. Operators
should be careful that they do not “oversteer,” that is turn
the wheel so that a turn is tighter than intended.
https://www.boat-manuals.com/lund/
To Next Page
Loading...