LIVEWELL
An aerated livewell and baitwell is available on some models.
The well or wells provide an environment where your catch can
be kept alive and healthy. Figure 3-1 shows a typical livewell.
The livewell on your boat may be slightly different than the one
shown.
NOTE: You should monitor water and air temperatures to
determine when and how often you should aerate the livewell.
Turning on the ACCY switch controls the operation of the
livewell pump. Open the valve (if provided) on the aerator
head before turning on the pump. The pump draws raw
water in through a fitting below the waterline and pumps it
into the livewell. The pump fills the livewell with raw water.
Water sprays into the livewell through the aerator head. As
the incoming water hits the surface of the water in the
livewell, the water’s oxygen content increases which helps
keep fish alive. As water continues to spray into the well,
excess water flows out through the standpipe and drains
overboard. Drain locations vary by model. The livewell
works best at trolling speeds or when the boat is at rest. At
faster speeds, the pump does not work properly because it
cannot draw water.
https://www.boat-manuals.com/lund/
To Next Page
Loading...