WINTERIZATION AND STORAGE
Apply a light coat of petroleum jelly to cover the ends of the
battery cables.
Fresh Water System
Remove water tank and drain. Make sure water supply
hoses from the tank are drained.
Livewell
Remove the standpipe tube and allow all water to drain
from the livewell. Run the livewell pump just long enough
to ensure that all water is removed. Remove the livewell
inlet hose and drain. Open the aerator spray head valve
and allow the water to drain.
Bilge
NOTE: Winterization of the bilge is applicable to some
models. Not all models have a bilge pump.
Clean and dry the bilge. Remove any materials, such as
rags, sponges, or other cleaning material. Remove bottom
drain plug. Store the plug in a plastic bag and tape it to the
throttle control lever so that it does not get lost or forgotten.
The bilge pump must be drained to prevent damage if it is
exposed to freezing temperatures. Pump or drain all of the
water out of the bilge. Then, allow the pump to run for a
few seconds to remove water from the pump before
removing and draining the pump outlet hose. The bilge
pump is water-cooled. Running the pump dry for an
extended period of time will damage the pump. Run pump
only as long as necessary.
https://www.boat-manuals.com/lund/
To Next Page
Loading...