SUPPORTING YOUR BOAT DURING
STORAGE
Pontoon Boats
Your trailer is the ideal support for your boat during storage
because it supports the boat under the main frames.
Loosen or remove all tie downs to relieve stress on the
hull. Place blocks under the axles to keep tires away from
the ground. Now is also a good time to repack the trailer
wheel bearings.
If your boat is not stored on the trailer, it should be stored
on 4x4 inch timbers wide enough to support all tubes
(Figure 7-1). Place the blocks under the keels at the
seams. If not properly supported, the welds or the tubes
themselves may open. Damaged welds will require repair
by your dealer before launching the boat after storage.
https://www.boat-manuals.com/lund/
To Next Page
Loading...