Personal Injury! The lanyard stop switch must never be
removed or modified and must always be kept free from
obstructions that could interfere with its operation.
The stop switch (Figure 2-10) incorporates a shutoff
switch, switch clip, lanyard between 4 and 5 feet (1220 and
1524 mm) long, and lanyard clip. The clip on one end of
the lanyard should be securely attached to the operator’s
clothing, arm or leg at a place that is free of obstructions
and allows free movement. The plate on the other end of
the lanyard must be attached to the engine switch in order
for the engine to run.
NOTE: The switch on your boat may be different from the
typical switch illustrated here. Refer to the engine manual
for more information.
If the operator moves too far away from the ignition switch,
the lanyard pulls the plate out of the switch and shuts off
the engine. Movement away from the switch can be the
https://www.boat-manuals.com/lund/
To Next Page
Loading...