8
Next Hop VLAN (Only for IPv6): The VLAN ID (VID) of the specific IPv6 interface associated with the gateway.
The given VID ranges from 1 to 4094 and will be effective only when the corresponding IPv6 interface is valid. If an
IPv6 gateway Address is a link-local Address, you must specify the next hop VLAN for the gateway. If the IPv6 gateway
Address is not link-local Address, the Switch will ignore the next hop VLAN.
X Add Interface: Click to Add a new IP Interface. A maximum of 8 interfaces are supported.
X Add Route: Click to Add a new IP Route. A maximum of 32 routes are supported.
X Save: Click to save any unsaved changes.
X Reset: Click to cancel any unsaved changes and revert to previously-saved values. Not available once changes are saved.
NTP
NTP (Network Time Protocol) is used to sync the Network time based on Greenwich Mean Time (GMT). When using the
NTP Mode you must manually specify an NTP server(s), the Switch will sync the time after saving the configuration.
To configure NTP settings, select Configuration > Quick Setup > System > NTP from the navigation menu.
NTP Configuration
X
Mode Menu: Indicates whether NTP is Enabled or Disabled.
X
Server 1 to 5: Enter the NTP Server DNS, IPv4 or IPv6 Address. For a list of Addresses simply search NTP Servers on any
online search engine.
X Save: Click to save any unsaved changes.
X Reset: Click to cancel any unsaved changes and revert to previously-saved values. Not available once changes are saved.
To Next Page
Loading...
Need help?
General
