7
IP Interfaces
Delete: Select this option to delete an existing IP Interface.
VLAN: The VLAN associated with this IP interface. Only Ports in this VLAN will be able to access this IP Interface. This
field is only available for input when creating a new Interface.
DHCPv4
X
DHCPv4 - Enable: Enable the DHCP client by checking the Enable checkbox. If this option is enabled the Switch will
configure the IPv4 Address and mask of the interface using DHCP. The DHCP client will announce the configured
System Name as hostname to provide local DNS lookup.
X
DHCPv4 - Fallback: The number of seconds the Switch will try to obtain a DHCP lease. After this period expires the
configured IPv4 Address will be used as the IPv4 interface Address. A value of zero disables the fallback mechanism,
the Switch will keep retrying until a valid DHCP lease is obtained. The available range is from 0-4294967295 seconds.
X
DHCPv4 - Current Lease: For DHCP interfaces with an active lease this column shows the current interface Address as
provided by the DHCP server.
IPv4
X
IPv4 - IPv4 Address: The static IPv4 Address of the interface (set to 192.168.0.4 by default). The field may also be left
blank if IPv4 operation on the interface is not desired. If DHCP is enabled this field is not used.
X
IPv4 – Mask Length: The IPv4 Network mask in number of bits (also called CIDR notation). Valid values are between
0 and 30 bits for an IPv4 Address. The field may also be left blank if IPv4 operation on the interface is not desired. If
DHCP is enabled, this field is not used.
DHCPv6
X
DHCPv6 - Enable: Enable the DHCP client by checking the Enable checkbox. If this option is enabled the Switch will
configure the IPv6 Address and mask of the interface using DHCP. The DHCP client will announce the configured
System Name as hostname to provide local DNS lookup.
X
DHCPv6 – Rapid Commit: Allows the Switch to change the IPv6 Address as soon as a new lease is advertised
to the interface.
X
DHCPv6 – Current Lease: For DHCP interfaces with an active lease this column shows the current interface Address
as provided by the DHCP server.
IPv6
X
IPv6 - Address: The static IPv6 Address of the interface (IPv4 with an Address of 192.168.0.4 is configured by default).
The field may be left blank if IPv6 operation on the interface is not desired.
X
IPv6 - Mask Length: The IPv6 Network mask length in number of bits (also called CIDR notation). Valid values are
between 1 and 128 bits for an IPv6 Address. The field may be left blank if IPv6 operation on the interface is not desired.
IP Routes
Delete: Select this option to delete an existing IP route.
Network: The destination IP Network or Host Address of this route. Valid format is standard IPv4 or IPv6 notation. A
default route can use the value 0.0.0.0 or IPv6 :: notation.
Mask Length: The destination IP Network or Host Mask in number of bits (also called CIDR notation). Valid values are
between 0-32 bits for IPv4 and 0-128 bits for IPv6 routes. Only a default route will have a mask length of 0.
Gateway: The IP Address of the routes Gateway. Valid format is standard IPv4 or IPv6 notation. The Gateway and
Network must be in the same Subnet.
To Next Page
Loading...
Need help?
General
