6
IP
The IP address of the switch is set to 192.168.0.4 (or 192.168.0.3 for the AMS-1208P) by default. The IP address can also be
obtained via the DHCP server for VLAN 1. To manually configure a custom IP address, you can change the switch default
settings to values that are compatible with your network. We also recommend configuring DNS servers and a Default
Gateway, allowing the switch to obtain time and date information.
To configure switch IP settings, select Configuration > Quick Setup > System > IP from the navigation menu.
IP Configuration
IP Configuration
Mode: Configure whether the IP stack should act as a Host or a Router. In Host Mode, IP traffic between interfaces will
not be routed (including VLANs). In Router Mode traffic is routed between all interfaces (including VLANs).
DNS Server: This setting configures the DNS name resolution of the Switch. The following Modes are supported:
X
From any DHCPv4 interfaces: The first DNS server offered from a DHCP lease to a DHCP-enabled interface
will be used.
X
No DNS server: No DNS server will be used.
X
Configured IPv4: Allows you to provide the IP Address of the DNS Server.
X
From this DHCPv4 interface: Specify from which DHCP-enabled interface a provided DNS server should
be configured.
X
From any DHCPv6 interfaces: The first DNS server offered from a DHCP lease to a DHCP-enabled interface
will be used.
X
Configured IPv6: Allows you to provide the IP Address of the DNS Server.
X
From this DHCPv6 interface: Specify from which DHCP-enabled interface a provided DNS server should
be configured.
X
DNS Proxy: When DNS proxy is enabled the Switch will relay DNS requests to the configured DNS server, and reply as
a DNS resolver to the client devices connected through the Switch.
To Next Page
Loading...
Need help?
General
