LX7000 Mar.2002
Page 16
AIRSPACE
This is a very important setting, which allows the pilot to define under what conditions the airspace will appear on
the display. The instruments are delivered with airspace ENABLE. There are 5 different types of airspace. Each has
different type of line to allow visible separation of different zones. The zones can be present all the time (setting
ON) or closed by setting OFF. Using setting ON for all kinds of airspace will overload the display, so we offer to
use settings, which are connected with zoom. The presence of individual airspace is connected with ZOOM (if not
ON or OFF).
Example!
Using setting for instance 50 km will make the airspace visible only by zoom 50 km and lower. If the zoom is
bigger than 50 km the particular airspace will not be visible.
Factory suggests settings described above.
• CTR. control zone
• R.P,D restricted, prohibited, dangerous
• TRA training zone
• TIZ traffic information zones
• TMA terminal zone
APT
The airports are displayed like symbols with names.
APT ZOOM: 50 km setting will show the airports only having zoom 50 km or lower, if the zoom is bigger than 50
km the airports will disappear completely not to overload the display (available settings ON, OFF, 5,10, 20, 50, 100
km)
APT NAME: The airports are not displayed only with symbols, some letters of the name or ICAO code can be
added. The pilot is able to choose between:
• ICAO will show ICAO code of the airport close to the symbol
• 2char. up to 8 char. will display first letters of the airport
• NONE, without letters, only symbol
To Next Page
Loading...
Need help?
General