LX7000 Mar.2002
Page 25
3.2.3.2 Airport selection, team function and wind calculation
After ENTER an edit menu will appear.
3.2.3.2.1 Airport selection
There are two ways to select an airport. The first direct way is using of ICAO code input. After code input the
airport is selected immediately.
By mistake use START button (or ZOOM) to step back. By unknown ICAO the indirect way should be used.
Simply confirm ICAO with ESC and select the state in which the airport is (v).
After the state is selected four stars are to be replaced with first four letters of the airport. All airports with the same
first four letters will be shown, use v to find the right one.
If you input less than four characters the offer of the airports will be bigger. Confirming all stars with enter or simple
after ESC all airports of the state will be present.
To Next Page
Loading...
Need help?
General