1. Before each use, complete the checklist below
ake sure all burner control knobs are in the “
ush and hold the control knob in for 2 – 5 seconds, allowing the igniter to heat up
fter ignition set the knob to the desired setting
Note: The rotisserie burner features a thermocouple sensor with a safety valve that
automatically shuts of the flow of gas if the burner goes out for any reason.
1. Before each use, complete the checklist below
ake sure all burner control knobs are in the “
ush and hold the control knob for 2 – 5 seconds
” position and continue to hold the knob in for an additional
30 – 60 seconds to allow the ther
mocouple to heat up and keep the safety valve open
Do you smell gas? If yes, shut of
f everything and call the gas company or a qualied plumber to
Do you smell gas? If yes, shut off everything and call the gas company or a qualied plumber to Do you smell gas? If yes, shut of
re you prepared to stay with the grill during the entire cooking process?
you need before starting the lighting process.
s your cooking area free and clear of any combustibles, besides your food, that might ignite?
no, clear the area before starting the lighting process,
o all control knobs turn freely?
f not, call for service, if yes, please continue.
f you are using a portable propane cylinder, is it connected and leak tested?
connection before continuing.
o you know where your grill’s main gas supply shut off valve is located?
re all burners properly seated in the grill with mounting legs in slots?
properly before continuing.
s the wind blowing just lightly and not blowing on the back of the grill?
wind subsides or turn your free standing grill so the wind goes into the front of the grill.
please continue with the lighting process.
HOW TO LIGHT YOUR ROTISSERIE BURNER
CHECKLIST BEFORE EACH USE (FOR YOUR SAFETY)
To Next Page
Loading...
Need help?
General
