Lynx L27-2 User Manual

34
G
AS
GASG
C
ONNECTIONS
T
he grill is factory set to use
either pr
opane (
LP
) or natural
gas (
either pr
gas (
either pr
NAT
).
opane (
).
opane (
I
t is critical that the
opane (
t is critical that the
opane (
gas you use matches that
which the grill was set up for.
gas you use matches that
which the grill was set up for.
gas you use matches that
Y
ou can verify that by
which the grill was set up for.
ou can verify that by
which the grill was set up for.
You can verify that by Y
checking the
rating plate
.
T
he rating plate is located in
one or more of the following
he rating plate is located in
one or more of the following
he rating plate is located in
places:
A
ttached to the underside
of the drip tray
O
n the heat shield behind
the front panel
O
n the inside left cabinet
wall
T
he Rating plate lists serial numbers,
model numbers and gas type.
he Rating plate lists serial numbers,
model numbers and gas type.
he Rating plate lists serial numbers,
T
his
he Rating plate lists serial numbers,
his
he Rating plate lists serial numbers,
one is underneath the drip tray.
one is underneath the drip tray.
model numbers and gas type.
one is underneath the drip tray.
model numbers and gas type.
model numbers and gas type.
one is underneath the drip tray.
model numbers and gas type.
E
nsure that the gas supplied
meets with the minimum
nsure that the gas supplied
meets with the minimum
nsure that the gas supplied
pr
essure requirements. Do not
operate the grill on any gas
pr
operate the grill on any gas
pr
essure requirements. Do not
operate the grill on any gas
essure requirements. Do not
other than that for which the
operate the grill on any gas
other than that for which the
operate the grill on any gas
grill has been set.
F
uel
WC
M
ax
I
nlet
WC
M
in
U
nder
F
ull
L
oad
N
at
G
as 7 in 4 in
as 7 in 4 in
as 7 in 4 in
LP
14 in 11 in
14 in 11 in
Water Column Requirements
Both the regulator and the
Both the regulator and the
manifold orices have been
manifold orices have been
Both the regulator and the
manifold orices have been
Both the regulator and the
Both the regulator and the
manifold orices have been
Both the regulator and the
tuned for the type of gas
tuned for the type of gas
specied on the rating plate.
tuned for the type of gas
specied on the rating plate.
tuned for the type of gas
C
onverting to a different type
of gas requires a conversion
onverting to a different type
of gas requires a conversion
onverting to a different type
kit, available from
of gas requires a conversion
kit, available from
of gas requires a conversion
L
ynx or
Lynx or L
fr
om your dealer and must be
installed by a qualied techni
om your dealer and must be
installed by a qualied techni
om your dealer and must be
-
cian.
A
ll installation and all instal-
lation parts must conform to
local codes with the
lation parts must conform to
local codes with the
lation parts must conform to
N
ational
lation parts must conform to
ational
lation parts must conform to
E
lectrical
C
ode,
ANSI
Z223.1/
NFP
A
NFPANFP
70 latest edition and
the
N
ational
F
uel
G
as
C
ode,
ANSI
Z223.1/
NFPA
54 in the
U
.
S
and
CGA
-B149.1/.2 in
C
anada.
C
anadian installations must
conform to
CGA
-B149.1/.2
natural gas/propane installa-
tion code. (
natural gas/propane installa-
tion code. (
natural gas/propane installa-
C
natural gas/propane installa-
C
natural gas/propane installa-
anada)
natural gas/propane installa-
anada)
natural gas/propane installa-
NATURAL GAS
L
ynx r
Lynx rL
ecommends that
only qualied profession
ynx r
only qualied profession
ynx r
-
als perform the required
only qualied profession
als perform the required
only qualied profession
plumbing on this product.
als perform the required
plumbing on this product.
als perform the required
T
o ensur
To ensurT
e satisfactory per-
formance, the gas supply
e satisfactory per-
formance, the gas supply
e satisfactory per-
line must be sized to ac-
formance, the gas supply
line must be sized to ac-
formance, the gas supply
commodate the total B
TU
requirements of all the gas-
red equipment that will be
requirements of all the gas-
red equipment that will be
requirements of all the gas-
connected to that line.
red equipment that will be
connected to that line.
red equipment that will be
I
n no case should pipe less
than 3/4” inside diameter or
n no case should pipe less
than 3/4” inside diameter or
n no case should pipe less
1” outside diameter ever be
used to connect this product.
C
alculate the total B
TU
output of all equipment
and refer to “
output of all equipment
and refer to “
output of all equipment
INDE
X:
G
output of all equipment
G
output of all equipment
as
S
upply
L
ine Runs” for
allowable run distances
upply
allowable run distances
upply
for ¾ inch pipe.
F
ailure
to meet these minimum
for ¾ inch pipe.
to meet these minimum
for ¾ inch pipe.
requirements may reduce
performance of the grill
requirements may reduce
performance of the grill
requirements may reduce
and any other appliances
performance of the grill
and any other appliances
performance of the grill
running on that supply line.
and any other appliances
running on that supply line.
and any other appliances
A
lways keep supply line
runs as short as possible.
lways keep supply line
runs as short as possible.
lways keep supply line
(
S
ee
INDE
X: “B
TU
O
utput” for
specic model ouputs)
A
gas shut-off valve must
be installed in an easily
accessible location by a
qualied plumber.
accessible location by a
qualied plumber.
accessible location by a
warning
Never co
NN
ect a gas li
N
e directly to the grill.
a
pressure regulator must be
i
N
stalled o
N
all gas equipme
N
t.
a
ll local codes require it a
N
d
l
y
lyl
N
x supplies the
correct regulator with your grill.
r
emovi
N
g or faili
N
g to i
N
stall the pressure
regulator ca
N
result i
N
fire a
N
d serious perso
N
al i
N
jury a
N
d will void the
warra
N
ty.

Lynx L27-2 Specifications

General

Brand	Lynx
Model	L27-2
Category	Grill
Language	English