16
3. Getting started
This chapter explains the way to use M3 for the first time.
Take the following procedure.
1. Click the Reset button: Unpack the M3 package. When using it for the first time,
the battery power is not connected to M3. If you lightly click the Reset button, the
battery power is automatically connected to M3. After 4 or 5 second, M3 enters into
hardware reset mode and load images in the flash ROM to SDRAM. The screen will
show Microsoft Windows CE 4.2 (CE.NET) logo and the seek bar. You can check out
the loading status through the seek bar. When images are fully loaded, the main
screen will appear. Now you are ready to use M3.
[Click the reset button]
2. Connect the battery charger: If you connect the charger to DC terminal of the
M3, the charge LED will become red. To use M3 safely, you have to charge M3 until
the charge LED turns into green. When battery is completely discharged, it will take
about 3 hours for M3 to be fully charged. You can also use M3 while it is on charge
status.
If the device is completely discharged, there is a risk of losing all data and
files. To prevent the loss of data, use its power save mode to prevent
power running out completely. If LED is flashing in red or a battery
discharge warning message continues to pop up, stop use the device and
use the charger to fill the battery.
To Next Page
Loading...
Need help?
General
