Setting the width of the work
- The workwidth of the agricultural
machine can be set with the
parameter given here. (The software
sets the width of the line (stripe),
which indicates the cultivated area.
The navigation distances are also
calculated based on this data.)
- Negative number cannot be given.
Setting the center-offset
- The outline of the cultivated area
can be moved to the left of the
agricultural machine with negative
values. It can move to the right of
the agricultural machine with
positive values.
- center-offset is not considered when
calculating the navigation path (not
supported when guidancing)
Setting the distance of the
antenna from the machinery
The software does not support
towed machines with joint.
To Next Page
Loading...