Magellan MAP 330 GPS Receiver 5
Setting Up the MAP 330
Setting Up the MAP 330
Press
ENTER
(You have 10 seconds to press ENTER or the MAP 330 will
shut off.)
Start-up Screen Warning Screen
The final step in setting up the MAP 330 is to initialize the receiver for first-
time use. This will help your MAP 330 begin computing your position in the
fastest manner possible.
The reason for initialization is to speed up the process for computing the first
position fix when the MAP 330 has no last position computed in memory (i.e.,
when the MAP 330 is brand new or memory has been cleared). This gives the
MAP 330 an approximate indication of where it is located so it can use its
satellite almanac (stored in permanent memory) to estimate what satellites are
overhead and which ones it should be looking for.
Follow these instructions to initialize the MAP 330.
Press
The MAP 330 turns on and displays the start-up screen and a
warning screen.
To Next Page
Loading...
Need help?
General