Tap
Stop
to
end
simulating
the current route you are simulating.
(The
Simulate
button is presently not active.)
4.
Tap
Back
arrow
to
record
the
changes and exit.
Setting
Tone
Options
Provides a way
of
selecting the tone used
to
announce arrival at a maneuver or destination.
1. From page 2
of
the
Main Menu, tap
User
Options.
2.
Tap
Tone
Options.
3. Select Bell,
Chime
or
Beep.
4.
Tap
Save
to
record the changes and exit.
Viewing Technical
GPS
Information
This screen provides technical information about
the
satellites being used
to
compute the
GPS
position.
1. From page 2
of
the
Main Menu, tap
User
Options.
2.
Tap
GPS
Options.
3.
Tap
GPS
Status.
PRN: pseudo random number
that
identifies
the
sate
II
ite
AZ: Azimuth
of
the satellite
EL: Satellite elevation
SNR: Satellite signal-to-noise ratio
TTFF: Time
to
First Fix (in seconds)
4.
Tap
Back
arrow
to
exit.
Setting the
GPS
Position
Setting a
GPS
position is useful
if
you are not
getting
satellite information
quickly
because the
Magellan Maestro has travelled over
500
miles while turned off. Setting the
GPS
position
will
allow
the Magellan Maestro
to
compute
which satellites are available and calculate the position quicker.
1. From page 2
of
the
Main Menu, tap
User
Options.
2.
Tap
GPS
Options.
3.
Tap
Set
GPS
Position.
4. Follow the prompts
to
enter
the
address where you currently are.
5.
Tap
Done
when finished entering the address.
User Options
45
To Next Page
Loading...
Need help?
General
