UDP (Multicast) indicates that the encoder sends the UDP stream to a
multicast group. It is used for one-to-many broadcast for lower CPU
utilization. Parameters in a multicast configuration include:
■
Multicast IP ranges from 224.0.0.0 to 239.255.255.255.
■
Subnet Mask can be legitimate value ranging from 255.0.0.0 to
255.255.255.0.
■
Time To Live ranges from 1 to 255. The default value is 4.
■
RUDP (Unicast) indicates that the encoder sends the reliable UDP
stream directly to the receiver.
■
TCP (Uni-connection) indicates that the encoder sends the TCP stream
directly to the receiver.
■
TCP (Multi-connection) indicates that the encoder sends the TCP
stream to more than one receiver.
■
Discovery Server: turn on the switch to auto-detect a source sender in
different network segment and ping the sender. And the Server IP should
be the IP address of the server running discovery server software. By default,
the switch is off.
■
Failover: turn on to protect your NDI transmission from failure. If the initial
source video fails, the backup device begins to provide a service. The initial
source will be automatically switched back to after it recovers. This function
is disabled by default.
■
Source name shows the backup NDI channel name.
Click Change... and select the failover (backup) video device within the
same NDI group as the initial source.
■
To Next Page
Loading...
