MAGGI TECHNOLOGY - BORING SYSTEM 23 - REV00 Pag. 35
4. Switch on the machine and let the spindles turn so that the grease is homogeneously spread within the
head
5. Switch off the machine
6. Verify that some grease has leaked out of the hole (C); if not, please, repeat the whole procedure once
again and until the grease is leaking out
7. lock the head cover back to the head by inserting the washer and screw in place ( A )
9. COMMON FAILURES: REASONS AND REMEDIES
Some failure causes can be eliminated directly by the operator, other by qualified personnel only.
THE MOTOR WORKS BUT THE DRILLS DO NOT
DRILLS DO NOT WORK
PROBABLE REASON ACTION
A - the motor does not
work
B - the motor is out of
service
push the motor start push button
release the emergency push button and/or check
fuse
check air pressure value (to turn on the pressure
sensor)
replace the motor
PROBABLE REASON ACTION
Possible failure of:
- gears and/ or keys
- drive joint
replace them or call technical service
TRY TO RESOLVE THE FAULTS FOLLOWING THE DESCRIPTION INDICATIONS
PUT THE MAXIMUM CAUTION IN PERFORMING THE OPERATIONS
WEAR INDIVIDUAL PROTECTIVE EQUIPMENT MORE SUITABLE FOR THE SPECIFIC
OPERATION TO BE PERFORMED
CONTACT THE ASSISTANCE SERVICE FOR ANY NEED
DPI - WEAR
PROTECTIVE
CLOTHES
DPI - WEAR
PROTECTIVE SHOES
DPI - WEAR
PROTECTIVE
GLOVES
To Next Page
Loading...