1. SAFETY RULES AND GENERAL INFORMATION
1.1 RECOMMENDATION FOR USE AND MAINTENANCE
In this manual we put into evidence all the operations for a correct use and ordinary maintenance of the
machine.
We strongly recommend not to make any other type of work repair or operation not suggested in this manual.
We suggest also to keep this manual in a place where the user can easily find and read it.
Make regular periodical inspections to check if safety protection devices work well (at the very first use of the machine,
at the start of every working shift and after long time of not use of the machine).
If any defects and/or malfunctions are put into evidence on safety protection devices, act as following:
Immediately stop the machine
Show and put into evidence the issue to the responsible for safety
Put on the machine a tag (sign) saying “DO NOT USE THIS MACHINE - OUT OF ORDER” (or something like that)
in a place on the machine where it is easy to be seen
Adopt immediately the necessary countermeasures so solve the problem
Before using the machine again after repair, check accurately that it is fine and all safety countermeasures are in
good state and work well
GENERAL INFORMATION ON THE MANUFACTURER
Manufacturer: MAGGI TECHNOLOGY S.r.l.
Address: Via delle Regioni, 299 - 50052
Town: CERTALDO (FI)
Country: ITALIA
Tel. +39 0571 63541
Fax. +39 0571 664275
E-mail: service@maggi-technology.com
MAGGI TECHNOLOGY - BORING SYSTEM 23 - REV00 Pag. 1
SAFETY PROTECTION DEVICE
ANY REMOVAL, EXCLUSION OR MODIFICATION OF SAFETY PROTECTION DEVICES IS
STRICTLY FORBIDDEN: ANY ADULTERATION OR REMOVAL OF ANY OF THESE
DEVICES CAN CAUSE SEVERE DAMAGE
NEVER LEAVE THE MACHINE UNATTENDED WHEN IN USE, FOR ANY REASON
WHEN THE MACHINE STOPS, WAIT FOR EVERY ORGAN IN MOTION TO BE ACTUALLY
STOPPED BEFORE LEAVING THE MACHINE.
MAINTENANCE:
Disconnect the machine from any energy sources: the electrical power supply and the
pneumatic air supply must be cut off and blocked
Check that any residuals energy has been actually consumed before performing any
maintenance interventions on the machine
Any maintenance operation must be performed only by specialized and/or authorized
personnel
Put on the machine a tag (sign), in a place easy to be seen, saying that the machine is
under maintenance anc can not be used for working
To Next Page
Loading...