1) A safe and correct use can be obtained by carefully and scrupulously following all the instructions
contained into this manual.
2) The machine must be used only by qualified users and personnel of age. The responsible for safety
must be sure that user of the machine have read and understood all the information contained into this
manual. The user must be well trained on the correct use of the machine, the safety protection devices
and of all the accessories.
3) The personnel for both ordinary and extraordinary maintenance must be well prepared in mechanics
and electricity.
4) Apply any ordinary maintenance operation at the planned time to keep the machine in good and safe
state.
The main danger is related to rotating tools and to moving/tilting drilling head and all the parts connected to it.
1.2. GENERIC NOTES
WOODWORKING MACHINES CAN BE DANGEROUS
Pag. 2 MAGGI TECHNOLOGY - BORING SYSTEM 23 - REV00
1.3. OPERATIVE WARNINGS
1) Before making any operation with the machine, verify that the entire working area is free of persons and of
any obstacles which could be potentially source of danger.
2) The connecting cable to the electrical power supply must be safe, well stretched out and not rolled up.
3) Do not put any inflammable substances nearby the machine because of risk of explosion and/or fire due to
possible sparks production.
4) The machine must be turned off when not in use.
5) Enter the drilling zone only if the machine is turned off. Keep out from any movin/rotating parts of the
machine. Never touch drilling heads and other moving parts while in motion.
6) The operator must think carefully about possible consequences before approaching with his hands the
most dangerous areas of the machine (the drilling zone, the tools, the working area of the clamp units).
7) The machine drilling devices must be correctly blocked and adjusted before use.
8) Before you switch on the machine or start any work session, check that the working table is free of the
shaving left from the wood previously drilled.
9) The operator must pay maximum attention using the pneumatic pedal to work with the machine.
10) Never place one working part over one another. Correctly set-up the amchine and then drill always only
one part at time.
Our machine is equipped with following protection devices to reduce risks to the minimum:
A) Emergency push button
It is inserted in the control panel, in the front side of the machine. All the movements of the machine stop
immediately when the emergency push button is pushed.
B) Series of stickers and plates
They describe in details all the safety instructions, the correct working procedures and identify the main parts of
the machine. One plate shows the identification and serial number of the machine.
C) Safety clamp (patented)
They are on the surface of the working table or of the already positioned working piece, so that the operator
can not put unintentionally his hands below.
D) Safety protection device
No-way-back coil preserve against accidental start. No-way-back coil preserve against accidental start
To Next Page
Loading...