Magicfx ECO2JET - Page 16

16 MAGICFX
®
ECO2JET
®
- User and Installation Manual
The following RDM parameters are supported by the ECO2JET
®
.
Parameter ID Discovery GET SET
DISC_UNIQUE_BRANCH X
DISC_MUTE X
DISC_UN_MUTE X
DEVICE_INFO X
SUPPORTED_PARAMETERS X
PARAMETER_DESCRIPTION X
SOFTWARE_VERSION_LABEL X
DEVICE_MODEL_DESCRIPTION X
MANUFACTURER_LABEL X
SLOT_DESCRIPTION X
SENSOR_DEFINITION X
SENSOR_VALUE X
DMX_START_ADDRESS X X
IDENTIFY_DEVICE X X
DEVICE_LABEL X X
DISPLAY_INVERT X X
RDM_PID_SET_ENABLE_ADDR X X
RDM_PID_HEATER_ENABLE X X
FACTORY_DEFAULTS X X
RESET_DEVICE X
RDM parameters
RDM parameters are subject of change due to soware updates. Contact MAGIC FX
for the latest information and updates.
The following sensors are available through RDM:
Sensor Description
Heating percentage The heater percentage is displayed to indicate the
status of the heater. It represents the progress of the
heat-up process. Once the device is ready, the
percentage reflects the remaining eect time.
Error code 0 = no error. All other numbers indicate an error.
Prime finished 0 = no
1 = yes