Magicfx ECO2JET - Prime the ECO2 JET; Blast with DMX

MAGICFX
®
ECO2JET
®
- User and Installation Manual 31
Mode Power
Heat-up
time
ECO 1.5 kW 18 min
FULL 3.5 kW 9 min
Heat-up power modes
Regardless of the power mode selected, the maximum duration of the eect is 8
seconds. Once this time elapses, the eect will automatically cease. To initiate the
eect again, you will need to deactivate and then reactivate the Eect trigger. This
will enable you to restart the eect and experience it once more.
NOTICE
The eect is the same in each heat-up power mode.
NOTICE
Keep in consideration that during the eect the heater
will cool down and the interval between two equal
eect durations not only depends on the eect time
used, but also on the set heat-up power mode.
3.7. PRIME THE ECO2JET
®
The ECO2JET
®
is equipped with a priming function designed to eliminate any trapped
air within the system and connected hoses. It is advisable to prime the ECO2JET
®
before each event if it is positioned at a height dierence of +1m relative to the
attached fluid canister, or if a new extension hose is used.
1. Make sure the device is heated up and a fluid canister is connected and the
heater is not disabled.
2. Set the DMX value for the enable channel between 200 and 255 to prime.
3. Set the DMX value for the start channel between 100 and 154 to prime.
4. The FX LED indicator will start blinking and some smoke will be generated by
the device.
5. When the FX LED indicator solidly lights up, the priming is done.
6. The enable and start channel may now be deactivated or the user may
continue with Chapter 3.8.Blast with DMX.
NOTICE
The device can also be operated using the Test Mode
menu. Keep safety regulations in mind when operating
manually.
3.8. BLAST WITH DMX
6
CAUTION
Make sure that the air grilles of the ECO2JET
®
are not
blocked.
NOTICE
In case the ambient temperature reaches unusually
high levels, the fan might engage at a low speed to
prevent the machine from overheating.