MAGICFX
®
ECO2JET
®
- User and Installation Manual 35
Code Meaning Solution
129 Hardware overheat error Internal device hardware is
overheated.
• Make sure the device is used
within its operating
temperature.
130 Temperature sensor fault Hardware temperature sensor
fault.
• Power cycle the device. If it
happens again, contact
MAGIC FX.
208 Temperature overheat warning • Make sure the device is used
within its operating
temperature.
211 Heat-up warning on • If it happens oen, contact
MAGIC FX.
212 Hardware overheat warning • Make sure the device is used
within its operating
temperature.
213 Heater o warning • This warning is displayed when
the user disabled the heater.
Troubleshooting
Always contact MAGIC FX if any malfunctions or (unlisted) errors occur that cannot
be solved with the instructions as described in this manual.
In this stage, MAGIC FX appreciates it if the occurrence of errors/warnings will be
reported as detailed as possible.
To Next Page
Loading...