Guide for Components
The hopper sensor and rollers
Clean the Inlet sensor and the roller as shown in the photo below with a soft
cotton towel or a brush.
Miscounting may be caused if dust, dirt, and other materials get stuck or clutter the sensors.
It is necessary to clean the sensors and rollers with an attached cleaner once a day.
Turn off the power switch before cleaning.
otherwise, this may result an electric shock or injury.
Do not use chemicals such as benzene, thinner, or water.
use of such may result in discoloring or breakage.
CAUTION
!
Daily Maintenance
<Inlet Sensor and Rollers>
-
--
-48
4848
48-
--
-
To Next Page
Loading...
