Magnetek FLEX EX2 - Program SW1 Function (TX); Program SW2 Function (TX); Program SW3 Function (TX)

Page 21
6.12 Program LX Joystick Function (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter LX Joystick setting.
3) Press “↑” and “↓” button to scroll and select between None, Analog, 1-step,
2-step, 3-step, 4-step and 5-step.
4) Exit Program LX Function by pressing the “BACK” button until the cursor is
shown next to “LX FUNC”.
5) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
Set each joystick’s number of steps and output type (analog-stepless or digital-stepped)
according to the hardware installed.
6.13 Program LY Joystick Function (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter LY Joystick setting.
3) Press “↑” and “↓” button to scroll and select between None, Analog, 1-step,
2-step, 3-step, 4-step and 5-step.
4) Exit Program LY Function by pressing the “BACK” button until the cursor is
shown next to “LY FUNC”.
5) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
Set each joystick’s number of steps and output type (analog-stepless or digital-stepped)
according to the hardware installed.
6.14 Program RX Joystick Function (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter RX Joystick setting.
3) Press “↑” and “↓” button to scroll and select between None, Analog, 1-step,
2-step, 3-step, 4-step and 5-step.
4) Exit Program RX Function by pressing the “BACK” button until the cursor
is shown next to “RX FUNC”.
5) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
Set each joystick’s number of steps and output type (analog-stepless or digital-stepped)
according to the hardware installed.
6.15 Program RY Joystick Function (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter RY Joystick setting.
3) Press “↑” and “↓” button to scroll and select between None, Analog, 1-step,
2-step, 3-step, 4-step and 5-step.
4) Exit Program RY Function by pressing the “BACK” button until the cursor is
shown next to “RY FUNC”.
5) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
Set each joystick’s number of steps and output type (analog-stepless or digital-stepped)
according to the hardware installed.