Page 6
4.7 Program Transmitter Inactivity Timer (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter Transmitting Timer setting.
3) Press “↑” and “↓” button to select __M, __S or ON (constant ON).
4) When Minutes or Seconds is selected, press “→” button to go to the first
digit on the left and press “↑” and “↓” button to select numeric value.
5) Press “→” button to go the next digit to the right and press “↑” and “↓”
button to select numeric value.
6) Press “→” button again to go to the next column to select “M” for minutes
and “S” for seconds. Press “↑” and “↓” button to select.
7) Press “BACK” button to go back to step 3 or 4.
8) Exit Program Transmitter Timer by pressing the “BACK” button until the
cursor is shown next to “TX TIMER”.
9) Press “↑” and “↓” button to scroll through other Flex EX settings.
4.8 Program Password (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter Password setting.
3) Press “→” button to go to the 1
st
digit on the far left.
4) Press “↑” and “↓” button to change numeric value.
5) Press “→” button to go to the next digit to the right and repeat step 4.
6) Press “BACK” button to go back to step 3.
7) Exit Program Password by pressing the “BACK” button until the cursor is
shown next to “PASS WORD”.
8) Press “↑” and “↓” button to scroll through other Flex EX settings.
Only PB1 through PB4 are used when using the password function. Numeric
value “1” represents PB1, “2” represents PB2, “3” represents PB3 and “4”
represents PB4.
Setting “1111” → Password function disabled (manufacture preset)
4.9 Program Pushbutton Functions (TX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter Pushbutton Function setting.
3) Press “↑” and “↓” button to change pushbutton function as a whole or…
4) Press “→” button to go to the digit on the far left.
5) Press “↑” and “↓” button to change numeric value.
6) Press “→” button to go to the next digit to the right and repeat step 5.
7) Press “BACK” button to go back to step 3 or 4.
8) Exit Program Pushbutton Functions by pressing the “BACK” button until
the cursor is shown next to “PB FUNC”.
9) Press “↑” and “↓” button to scroll through other Flex EX settings.
The transmitter pushbutton function table on Section 12 Part-A illustrates which numeric value
corresponds to which pushbutton function.
To Next Page
Loading...
Need help?
General
