Magnetek FLEX EX2 - Program LX Output (RX); Program LY Output (RX)

Page 31
6.31 Program LX Delay (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter LX Delay setting.
3) Press “↑” and “↓” button to select delay for ACC (forward motion) and DEC
(reverse motion).
4) Press “→” button to enter and press “↑” and “↓” button to scroll and select.
5) Press “BACK” button to go back to step 3.
6) Exit Program LX Delay by pressing the “BACK” button until the cursor is
shown next to “LX DELAY”.
7) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
6.32 Program LY Delay (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter LY Delay setting.
3) Press “↑” and “↓” button to select delay for ACC (forward motion) and DEC
(reverse motion).
4) Press “→” button to enter and press “↑” and “↓” button to scroll and select.
5) Press “BACK” button to go back to step 3.
6) Exit Program LY Delay by pressing the “BACK” button until the cursor is
shown next to “LY DELAY”.
7) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
6.33 Program RX Delay (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter RX Delay setting.
3) Press “↑” and “↓” button to select delay for ACC (forward motion) and DEC
(reverse motion).
4) Press “→” button to enter and press “↑” and “↓” button to scroll and select.
5) Press “BACK” button to go back to step 3.
6) Exit Program RX Delay by pressing the “BACK” button until the cursor is
shown next to “RX DELAY”.
7) Press “↑” and “↓” button to scroll through other Flex 2JX settings.
6.34 Program RY Delay (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “→” button to enter RY Delay setting.
3) Press “↑” and “↓” button to select delay for ACC (forward motion) and DEC
(reverse motion).
4) Press “→” button to enter and press “↑” and “↓” button to scroll and select.
5) Press “BACK” button to go back to step 3.
6) Exit Program RY Delay by pressing the “BACK” button until the cursor is
shown next to “RY DELAY”.
7) Press “↑” and “↓” button to scroll through other Flex 2JX settings.