51
mWing
Installation and assembly
9. Remove excess construction adhesive as soon as possible with "Klebt + Di-
chtet Entferner". If the construction adhesive has already cured, remove
excess construction adhesive with a suitable tool. When selecting the tool,
consider the material of the base.
10. Wait for the curing time.
11. Place the pedestrian gate on the base plate. ä Page 52, Fig. 22.
12. Place washers and hexagonal screws.
NOTICE
Possible damage to the finished floor!
Use screws M8 x 16 from attachment set BSS100. Do not use the M8 x 30
screws.
13. Slightly tighten the screws.
14. Align the pedestrian gate.
15. Tighten the screws firmly.
16. If necessary, seal the base plate laterally with a silicone joint.
17. Arrange electrical connections. ä Page 59, chapter 8.
18. Mount strips, side parts, and cover. ä Page 53, chapter 7.8.
To Next Page
Loading...