Magnetrol E3 Modulevel - Advanced Configuration and Diagnostics; Accessing Diagnostic Screens; Model-Specific and Calibration Settings; Accessing Calibration Sub-menus

14
MENU: STEP BY STEP PROCEDURE: ADVANCED CONFIGURATION
Screen Action Comment
Diagnostics
1
3
4
5
6
7
DispFact
Select
Run time
xxxx.x h
2
History
(current status)
History
Reset
MeasType
(select)
13
Weight
xx.x kg
Model
(select)
SpringSG
(select)
8
9
19
SprgRate
x.x
SprgMatl
10
TempLimt
xxx C
11
Length
xx.xx cm
1
2
Diameter
x.xxx cm
14
Lower SG
x.xx
15
Upper SG
x.xx
16
CalSelct
(select)
17
Factory
Cal Menu
User
Cal Menu
AdjSnrHi
18
AdjSnrLo
20
Conv Fct
xxxx
21
Scl Ofst
xxx
24
22
LVDT%
xx.xx %
23
Chan 0
Chan 1
25
NSP Value
27
26
ElecTemp
xxx C
Max Temp
xxx C
28
Min Temp
xxx C
R
eview factory parameters
S
elect «YES» to reveal Factory parameters; «NO» to hide.
R
eview Diagnostic messages.
A
cumulative review of all diagnostic messages. Press the enter but-
t
on twice to clear.
Display mode. Shows time in hours that unit is in operation since last power on.
D
iagnostic display.
S
elect «YES» to clear «History».
F
actory set.
L
evel, IfcLevel or Density.
F
actory set.
E
31, E32, E33, E34, E35, E36.
Factory set. Model specific.
F
actory set.
M
odel specific.
Factory set. Model specific.
F
actory set.
M
odel specific. Max process temperature for which unit is suitable.
Factory set. Model specific. Length of measuring range.
Factory set. Model specific. Outside diameter of displacer.
Factory set. Model specific. Weight of displacer
Factory set. Only for interface units.
Factory set. Only for interface units.
Select factory or user calibration. Selects calibration parameters used to calculate the measured PV.
Depress enter to display the
factory calibration sub-menu.
CalSelct = factory submenu on page 15
Depress enter to display the
factory calibration sub-menu.
CalSelct = user submenu on page 15
Diagnostic display.
Diagnostic display.
None, do not adjust. Factory setting.
None, do not adjust. Factory setting.
Diagnostic display.
Diagnostic display.
Diagnostic display.
Diagnostic display.
None, do not adjust. Diagnostic display, shows current internal housing temperature
recorded.
None, do not adjust. Diagnostic display, shows maximum internal housing temperature
recorded.
None, do not adjust. Diagnostic display, shows minimum internal housing temperature
recorded.
Hidden diagnostic screens. Do not access without assistance or having followed advanced training.