11
BE 57-660 Eclipse Model 700 Guided Wave Radar Transmitter
1.4.1.1 QuickStart Numerical Data Entry
To make numerical entry changes to Probe Length and
Level Offset:
UP moves up to the next highest digit (0,1,2,3,....,9 or
the decimal point).
If held down the digits scroll until the push button is
released.
DOWN moves up to the next lowest digit (0,1,2,3,....,9
or the decimal point). If held down the digits scroll until
the push button is released.
BACK moves the cursor to the left and deletes a digit.
If the cursor is already at the leftmost position, then the
screen is exited without changing the previously saved
value.
ENTER moves the cursor to the right. If the cursor is
located at a blank character position, the new value is
saved.
Scrolling further DOWN in the QuickStart menu results in
the remaining parameters appearing one by one, with the
present highlighted value shown at the bottom of the
screen.
BACK returns to the previous menu without changing
the original value, which is immediately redisplayed.
ENTER accepts the displayed value and returns to the
previous menu.
Negative values can be entered by highlighting the “+” sign
shown prior to the number, then pressing UP to change it
to show “-”.
▲
▲
▲
▲▲
▲
To Next Page
Loading...
