Mahindra 10 Series - Hydraulic Filter and Coolant Maintenance; Hydraulic and Engine Oil Filter Replacement; Changing the Coolant

► HYDRAULIC OIL FILTER AND ENGINE OIL FILTER CARTRIDGE
Never use petrol (gasoline) thinner or similar inflammable material to wash the primary
fuel filter.
After replacing the filter always bleed the system.
Important
Remove the filter with a filter wrench.
To replace, apply oil or grease on the seal, fit by hand until seal contacts bare, then turn it 2/3
rd
turn
further to tighten it and check for leaks.
CHANGING THE COOLANT
(1) Open the tap in front of the gear pump to drain the coolant.
(
2
)
O
p
en the radiator ca
p
at the same time.
()
pp
(3) To give a thorough clean run a hose into the radiator and
flush it out.
(4) Close the tap and refill the radiator with a coolant
mixture of water and corrosion inhibitor or anti freeze.
(5) Start the engine and allow it to run for approx 5 minutes,
check the water level again and top off if required .
Reservoir Tank
71