AIR CONDITIONER COMPRESSOR BELT ADJUSTMENT
Check the compressor belt tension regularly and adjust
If required.
The tension is correct when the center of the belt is
Pushed With a finger and it moves approx.
SERVICING THE AIR CLEANER
To remove the dust from the evacuator valve, squeeze it between
thumb and fin
ers to let excess dust out and wi
e around the
mm
.
n
as s
own
n t
e p
cture.
To adjust the belt, loosen or tighten the nut as shown in
the picture.
valve to keep it clean from outside.
To clean the main element, remove the right fan cover.
Remove the element by unloading the wing nut.
Remove dust by blowing it out of the element with
Compressed air.
Check the element to ensure that it is not damaged.
Reassemble the element.
evacuator
Never beat the element on a stone or concrete floor/wall to clean it. Check all
connections and hoses, especially on the clean side of the air cleaner to ensure no dusty
air can enter the engine.
Check the element for flaws by putting a light inside the element.
When reassembling make sure all surfaces seal correctly to keep dust out.
When working in dusty conditions increase the service frequency.
Important
▶Replace the element after cleaning it 5 times or if if is damaged.
CHECKING HOSES AND LINES
.
The fuel lines, radiator hoses, hydraulic and rubber hoses are consumables, which deteriorate by age and
use.
Check them regularly and replace if faulty.
Damaged fuel lines leak and cause fires.
Damaged radiator hoses can cause hot water burns and in severe cases seize the
engine.
Caution
78
To Next Page
Loading...
Need help?
General
